How to print PCTG filament

PCTG is a copolyester like PETG, so if you can print PETG, you already have a good head start. Here is a starting point.

Typical starting settings

Nozzle temperatureMany PCTG filaments print around 230–270 °C, but always begin with the filament maker's recommendation.
Bed temperatureAbout 70–90 °C
Part cooling fanLow to moderate; more for bridges and overhangs
EnclosureUsually not needed; avoid strong drafts
First layerSlower, not over-squished

These ranges are general guidance only. Every brand and color behaves a little differently, so start with your filament maker's recommended settings and adjust from there, staying within the limits of your printer and build surface.

1. Start from a PETG profile

Many makers start with their PETG profile and adjust: raise the nozzle temperature somewhat, then fine-tune with a temperature tower. Watch for good layer bonding and a clean surface.

2. Choose the right build surface

Like PETG, PCTG can stick very firmly to some smooth surfaces, such as smooth PEI or glass. In some cases excessive adhesion may damage certain smooth build surfaces during removal. To help protect your plate:

3. Get the first layer right

Print the first layer a little slower. Avoid over-squishing it: copolyesters tend to pick up on the nozzle and leave blobs when the first layer is too close.

4. Set cooling and retraction

Moderate cooling helps overhangs while still letting layers bond. PCTG can string, so tune retraction gradually and avoid large jumps in settings. See stringing and adhesion fixes.

5. Ventilation

Many users report relatively low odor from PCTG compared with some engineering polymers, but any 3D printing can release fumes and fine particles. Print in a well-ventilated room and follow your printer and filament makers' safety guidance.

Storage

Copolyesters can pick up moisture from the air over time, which may lead to stringing, popping, or a rough surface. If you see those signs, drying the spool following the maker's guidance often helps. Store spools sealed with desiccant between prints.

Because copolyesters can absorb moisture over time, consistent dry storage often has a greater effect on print quality than small temperature adjustments.